Hyundai Accent Manuals

Hyundai Accent: Installation - ETC (Electronic Throttle 
Control) System. Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Installation is reverse of removal.

Electronic throttle body Installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)


Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the resonator and the air intake hose (Refer ...

Adjustment
ETC module learning procedure When installing new ETC module or re-installing it, ETC module learning procedure must be performed. 1. Hold the ignition k ...

See also:

Components and Components Location
Component Location 1. Head lamp (Low / High) 2. Turn signal lamp 3. Front fog lamp 4. Position lamp 5. Turn signal lamp (Side repeater) 6. High mounted stop lamp ...

General Service Information
Protection Of The Vehicle Always be sure to cover fenders, seats, and floor areas before starting work. The support rod m ...

Engine compartment
1. Engine coolant reservoir 2. Windshield washer fluid reservoir 3. Radiator cap 4. Engine oil filler cap 5. Engine oil dipstick 6. Brake/clutch fluid reservoir 7. Air cleaner 8. Fuse box 9. ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com