Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Brake System / ESC(Electronic Stability Control) System / Rear Wheel Speed Sensor. Repair procedures / Removal

1.

Remove the rear wheel and tire.

Tightening torque:

88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

2.

Remove the rear wheel speed sensor mounting bolt (A).

Tightening torque:

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.8 lb-ft)

3.	Remove the rear seat back. (Refer to the Body group - Seat)

4.	Remove the rear wheel housing trim. (Refer to the Body group – interior trim)

5.	Disconnect the rear wheel speed sensor connector.

6.	Installation is the reverse of removal.

Rear Wheel Speed Sensor. Repair procedures

...

Inspection

1. Measure the output voltage between the terminal of the wheel speed sensor and the body ground. ...

See also:

Sunglass holder
To open the sunglass holder, press the cover and the holder will slowly open. Place your sunglasses in the compartment door with the lenses facing out. Push to close. WARNING Do not keep ob ...

Rear Wheel Alignment
When using a commercially available computerized wheel alignment equipment to inspect the rear wheel alignment, always position ...

Battery replacement
The transmitter uses a 3 volt lithium battery which will normally last for several years. When replacement is necessary, use the following procedure. 1. Insert a slim tool into the slot and gentl ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com