Hyundai Accent: Inspection
Antenna Cable
| 1. |
Remove the antenna jack from the audio unit and antenna.
|
| 2. |
Check for continuity between the center poles of antenna cable.
|
| 3. |
Check for continuity between the outer poles of antenna cable.
There should be continuity.
|
| 4. |
If there is no continuity, replace the antenna cable.
|
| 5. |
Check for continuity between the center pole (A) and outer pole
(B) of antenna cable. There should be no continuity.
|
| 6. |
If there is continuity, replace the antenna cable.
|
Removal
1.
Remove the rear roof trim.
(Refer to the Body group - Roof trim).
2.
Disconnect the antenna cable (A).
3 ...
See also:
Adjustment
ETC module learning
procedure
When installing new ETC module or re-installing it, ETC module
learning procedure must be performed.
1.
Hold the ignition k ...
To increase cruise control set speed
Follow either of these procedures:
Push the RES+ switch and hold it. Your vehicle will accelerate. Release
the switch at the speed you want.
Push the RES+ switch and release it immediately. ...
If engine turns over normally but does not start
1. Check fuel level.
2. With the ignition switch in the LOCK position, check all connectors at ignition
coils and spark plugs. Reconnect any that may be disconnected or loose.
3. If the engine sti ...
Hyundai Accent Manuals
В© 2011-2025 Copyright www.hamanual.com