Hyundai Accent: Removal
| 1. |
Remove the rear roof trim.
(Refer to the Body group - Roof trim).
|
| 2. |
Disconnect the antenna cable (A).
|
| 3. |
Remove the roof antenna (A) after removing a nut.
|
Inspection
Antenna Cable
1.
Remove the antenna jack from the audio unit and antenna.
2.
Check for continuity between the center poles of antenna cable ...
Installation
1.
Install the roof antenna and connect the cable.
2.
Install the roof trim.
...
See also:
Accelerator Position Sensor
(APS). Schematic Diagrams
Circuit Diagram
(M/T)
(A/T)
...
Introduction
With the Tire Mobility Kit you stay mobile even after experiencing a tire puncture.
The system of compressor and sealing compound effectively and comfortably seals
most punctures in a passenger c ...
ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between
ECM and chassis ground using the backside of ECM harness connector as
ECM side check point. If the problem is fo ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com