Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Body Electrical System / Multifunction switch / Repair procedures / Installation

Multifunction Switch

1.	Install the multifunction switch.

2.	Install the clock spring.

3.	Install the steering column upper and lower shrouds.

4.

Install the steering wheel.

Make sure the multifunction switch connectors are plugged in properly.

Flasher Unit

1.	Install the flasher unit.

2.

Fasten the bolt and connect the flasher unit connector.

Make sure the flasher unit connector is plugged in properly.

Removal

Wiper and Washer Switch 1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper (A) and lower (B) shrouds aft ...

Horn

...

See also:

Adjustment
ETC module learning procedure When installing new ETC module or re-installing it, ETC module learning procedure must be performed. 1. Hold the ignition k ...

Troubleshooting
Troubleshooting Trouble Symptom Probable cause Remedy Vehicle pulls to one side Scoring of driveshaft ball joint Replace ...

SS-A Solenoid Valve(ON/OFF). Description and Operation
Description SS-A solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears. SS-A Solenoid valve(ON/OFF) is installed at valve body. ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com