Hyundai Accent: Installation

Removal

1. Release the residual pressure in fuel line (Refer to “Release Residual Pressure in Fuel Line” in this group). 2. Remove the rear sea ...

Fuel Pump. Repair procedures

...

See also:

Inspection
Armature 1. Remove the starter. 2. Disassemble the starter as shown at the beginning of this procedure. 3 ...

Cylinder Block. Components and Components Location
Components 1. Cylinder block 2. Ladder frame 3. Crankshaft 4. Crankshaft upper bearing 5. Crankshaft lower bearing 6. Thrust bearing 7. Main bearing cap ...

Inspection
1. Turn ignition switch OFF. 2. Disconnect the oil temperature sensor connector. 3. Measure resistance between ...