Hyundai Accent Manuals

Hyundai Accent: Function - Description and Operation - Keyless Entry - Body Electrical SystemHyundai Accent: Function

Hyundai Accent RB (2010-2018) Service Manual / Body Electrical System / Keyless Entry / Description and Operation / Function

Keyless Entry Function
DOOR LOCK / UNLOCK are performed with remote controller.
1.
Keyless entry function is performed in a state that key in switch is eliminated from key cylinder
2.
LOCK / UNLOCK signals are received from the transmitter and DOOR LOCK / UNLOCK signals are output.
Transmitter(TX) Spec
1.
Transmission Distance : 10m or more from outside of the car
2.
Registration procedure of the transmitter
(1)
In registration mode, it shall be possible to register up to Max 4EA.
(2)
At re-registration, data are registered newly after deleting the previous TX DATA
No.
 Saved CODE
 CODE to change
 Changed CODE
1
 None
 A
 A
2
 A
 B
 B(A is deleted)
3
 B
 C,D
 C,D(B is deleted)
4
 C,D
 E,F,G
 E,F,G(C,D is deleted)
5
 E,F,G
 H,I,J,K
 H,I,J,K(E,F,G is deleted)
6
 A,B
 C,D,E,F,G
 C,D,E,F
7
 A,B
 C,C,D,E,F
 C,D,E
8
 A,B,C,D
 A
 A
9
 A,B,C,D
 E
 E

(3)
For the registration procedures by using Diagnostic tester, refer to "TRANSMITTER CODE REGISTRATION".
3.
Transmitter signal & Receiver specification
(1)
Transmission signal
A.
Transmit relevant transmission DATA (Transmission frame) twice by pushing TX SW.
B.
Only LOCK signal is output when pushing TX LOCK switch and UNLOCK switch at the same time.

Description
Keyless Entry System The keyless entry system allows you to lock and unlock the vehicle with the remote transmitter. When you push the LOCK button, all doors lock. When you push the UNLO ...

Repair procedures
Inspection Front Door Lock Actuator 1. Remove the front door trim. (Refer to the Body group - Front door) 2. Remove the front door ...

See also:

Inspection
1. Disconnect the back up lamp switch connector (A). 2. Check the continuity between no. 1 and 2 terminals of backup lamp switch. W ...

Underdrive Brake Control Solenoid Valve(UD/B_VFS). Specifications
Specifications Direct control VFS[UD/B] ▷ Control type : Normal high type Control Pressure kpa (kgf/cm², psi) 500.14 ~ 9.81 (5.5 ~ 0.1, 7.82 ~ 1.42) ...

Inspection
1. Insert a thin stick (A) into the PCV valve (B) from the threaded side to check that the plunger movement. ...

Hyundai Accent Manuals

В© 2011-2026 Copyright www.hamanual.com