Hyundai Accent: Repair procedures
Inspection
| 1. |
Remove the front door trim.
(Refer to the Body group - Front door)
|
| 2. |
Remove the front door latch.
(Refer to the Body group - Front door).
|
| 3. |
Disconnect the connectors from the actuator.
|
| 4. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
| 1. |
Remove the rear door trim.
(Refer to the Body group - Rear door)
|
| 2. |
Remove the rear door latch.
(Refer to the Body group - Rear door)
|
| 3. |
Disconnect the connectors from the actuator.
|
| 4. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
| 1. |
Remove the front door trim.
(Refer to the Body group - Front door)
|
| 2. |
Remove the front door latch.
(Refer to the Body group - Front door).
|
| 3. |
Disconnect the connectors from the actuator.
|
| 4. |
Check for continuity between the terminals in each switch position
when inserting the key into the door according to the table.
|
| 1. |
Remove the rear door trim.
(Refer to the Body group - Rear door)
|
| 2. |
Remove the rear door latch.
(Refer to the Body group - Rear door)
|
| 3. |
Disconnect the connectors from the actuator.
|
| 4. |
Check for continuity between the terminals in each switch position
according to the table.
|
| 1. |
Disconnect the negative battery terminal.
|
| 2. |
Remove the rear trunk lid trim, and then remove the trunk lid
switch from the actuator.
|
| 3. |
Check for continuity between the terminals in each switch position
according to the table.
|
| 1. |
Remove the steering column upper (A) and lower (B) shrouds after
removing 3 screws.
|
| 2. |
Disconnect the connector (6p) from the door warning switch.
|
| 3. |
Check for continuity between the terminals in each position according
to the table.
|
Function
Keyless Entry Function
DOOR LOCK / UNLOCK are performed with remote controller.
1.
Keyless entry function is performed in a state that key in switch
is eliminated ...
Transmitter. Specifications
Specifications
Item
Specification
Rated voltage
DC 3V
Service voltage range
DC 2.7V ~ 3.5V
Temperatu ...
See also:
Inspection
1.
Check that the light operate according to the following timing
chart.
2.
If the daytime running light is not operated well, insp ...
Radial-ply tires
Radial-ply tires provide improved tread life, road hazard resistance and smoother
high speed ride. The radial- ply tires used on this vehicle are of belted construction,
and are selected to comple ...
TPMS (Tire Pressure Monitoring System) malfunction indicator
The TPMS malfunction indicator will illuminate after it blinks for approximately
one minute when there is a problem with the Tire Pressure Monitoring System. If
the system is able to correctly d ...
Hyundai Accent Manuals
