Hyundai Accent: Body Control Module (BCM). SpecificationsSpecifications
|
Item |
Requirement |
Remark |
|
Rated voltage |
DC 12V |
Shall activate normally in these range. |
|
Operating voltage range |
DC 9 ~ 16V |
|
|
Operating temperature range |
-30°C ~ +75°C (-22°F ~ +167°F) |
|
|
Storage temperature range |
-40°C ~ +85°C (-40°F ~ +185°F) |
|
|
Max humidity in use |
95% |
|
|
High voltage resistance |
24V |
|
|
Insulation resistance |
100MΩ or more (measured with 500V MEGGER) |
Specify as well as parts that insulation like PCB, moisture-proof
COATING is required |
|
Dark Current |
Max 4mA |
Measure when the state, all output loads are OFF and there are no
Input SW(including TX operation) changes, continues 2sec. |
|
Voltage drop |
1.2V or less |
Output terminals for POWER WINDOW RELAY shall be 2.0V or less |
|
NO |
System name |
Capacity |
|
1 |
Room lamp |
DC 12V 20W(Lamp load) |
|
2 |
Power door relay |
DC 12V 200mA(Inductive load) |
|
3 |
Hazard relay |
DC 12V 200mA(Inductive load) |
|
4 |
Door lock relay |
DC 12V 200mA(Inductive load) |
|
5 |
Door unlock relay |
DC 12V 200mA(Inductive load) |
|
6 |
Driver door unlock relay |
DC 12V 200mA(Inductive load) |
|
7 |
Tail lamp relay |
DC 12V 200mA(Inductive load) |
|
8 |
Horn relay |
DC 12V 200mA(Inductive load) |
|
9 |
Interior autocut |
DC 12V 200mA(Inductive load) |
Hill-start assist control (HAC)
Hill start Assist Control is a convenience function. The main intent is to prevent
the vehicle from rolling backwards while taking off uphill from a stop. HAC holds
the braking pressure built up b ...
Rear Seat Belt. Repair procedures
Replacement
Rear Seat Belt Replacement
[Sedan]
•
When installing the belt, make s ...
Fuel Pressure Control Valve. Description and Operation
Description
Fuel Pressure Regulator Valve is installed on the high pressure
fuel pump and controls fuel flow flowing into the injectors in accordance with
the ECM signal calculated based on ...