Hyundai Accent: BCM (Body Control Module)

Transmitter Code Registration (Using GDS)

1. Connect the DLC cable of GDS to the data link connector (16 pins) in driver side crash pad lower panel, turn the power on GDS. 2. ...

Body Control Module (BCM). Specifications

Specifications Item Requirement Remark Rated voltage DC 12V Shall activate normally in these range. Operat ...

See also:

Installation
1. Install the overhead console lamp after connecting the sunroof switch connector and lamp connector. 2. Install the lens after tightening ...

Removal
1. Disconnect the battery negative cable and wait for at least 3 minutes before beginning work. 2. Remove the roof trim. (Refer to ...

Resetting the sunroof
Whenever the vehicle battery is disconnected or discharged, or related fuse is blown, you must reset your sunroof system as follows: 1. Turn the ignition switch to the ON position and close the sun ...