Hyundai Accent: Power Door Lock Actuators. Repair
proceduresInspection
| 1. |
Remove the front door trim.
(Refer to the BD group - "Front door")
|
| 2. |
Remove the front door latch.
|
| 3. |
Disconnect the 5P connector from the actuator.
|
| 4. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
| 1. |
Remove the rear door trim.
(Refer to the BD group - "Rear door")
|
| 2. |
Remove the rear door latch.
|
| 3. |
Disconnect the 5P connector from the actuator.
|
| 4. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
| 1. |
Remove the front door trim panel.
(Refer to the BD group - "Front door")
|
| 2. |
Remove the front door latch.
|
| 3. |
Disconnect the 5P connector from the actuator.
|
| 4. |
Check for continuity between the terminals in each switch position
when inserting the key into the door according to the table.
|
| 1. |
Remove the rear door trim panel.
(Refer to the BD group - "Rear door")
|
| 2. |
Remove the rear door latch.
|
| 3. |
Disconnect the 5P connector from the actuator.
|
| 4. |
Check for continuity between the terminals in each switch position
according to the table.
|
Components and Components LocationVariant coding
After replacing the SRSCM with a new one, must be performed the “Variant
Coding” procedure.
1.
On ...
Installation
•
Install the component with the specified
torques.
•
...
Automatic climate control system
1. AUTO (automatic control) button
2. OFF button
3. Temperature control knob
4. A/C display
5. Air intake control button
6. Fan speed control knob
7. Air conditioning button
8. Mode selection ...