Hyundai Accent Manuals

Hyundai Accent: Installation - Front Wiper Motor. Repair procedures - Windshield Wiper/Washer - Body Electrical SystemHyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Body Electrical System / Windshield Wiper/Washer / Front Wiper Motor. Repair procedures / Installation

1.
Install the wiper motor.
2.
Install the crank arm.
3.
Install the lower and upper linkage to the wiper motor crank arm.
To install the wiper motor crank arm, make sure that the linkage is aligned with the crank arm in straight line and set the angle of each linkage exactly.
Be careful not to bend the linkage.
4.
Install the wiper motor and linkage assembly and then connect the wiper motor connector.
Tightening torque :
7 ~ 11Nm (0.7 ~ 1.1, kgf.m, 5.0 ~ 7.9 lb-ft)
5.
Install the cowl top cover.
6.
Install the windshield wiper arm and blade.
Tightening torque :
27.5 ~ 31.4 Nm (2.8 ~ 3.2 kgf.m, 20.3 ~ 23.1 lb-ft)
-
The windshield wiper motor must be cycled to make sure that it is in the auto stop position.
If necessary, adjust the wiper arm and blade.
7.
Install the wiper arm and blade to the auto stop position.
A : Glass marking point
8.
Set the cowl top cover on the specified spray position.
-
When you turn on the washer, confirm 50% or more of washer fluid lands within the spray area.
-
If the spray area is not within the standard positions, adjust the nozzle(s).

Specified position
 Distance(in)
 Distance(mm)
A
 20.5
521
B
 21.1
536
C
 5.2
133
D
 5.8
147
E
 17.6
446
F
 12.2
311
G
 9.1
230
H
 9.0
229
I
 12.1
308
J
 17.3
440
K
 11.6
294
L
 12.0
306


Removal
1. Loosen the windshield wiper arm nut (A) after removing a wiper cap (B). 2. Remove the windshield wiper arm and blade. ...

Inspection
Speed Operation Check 1. Remove the connector (A) from the wiper motor. 1. - 2. IGN+ 3. Parking 4. High 5. GND ...

See also:

Removal
When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below. [In the ...

Heated Oxygen Sensor (HO2S). Schematic Diagrams
Circuit Diagram (M/T) (A/T) ...

Description and Operation
Description Ignition timing is controlled by the electronic control ignition timing system. The standard reference ignition timing data for the engine operating conditions are pre-programmed ...

Hyundai Accent Manuals

В© 2011-2026 Copyright www.hamanual.com