Hyundai Accent: Removal
When replacing the ECM, the vehicle equipped with
the immobilizer must be performed procedure as below.
[In the case of installing used ECM]
1) Perform "ECM Neutral mode" procedure with GDS.
(Refer to Body Electrical System - "Immobilizer system")
2) After finishing "ECM Neutral mode", perform "Key
teaching" procedure with GDS. (Refer to Body Electrical System - "Immobilizer
system")
[In the case of installing new ECM]
Perform "Key teaching" procedure with GDS. (Refer
to Body Electrical System - "Immobilizer system")
|
| 1. |
Turn ignition switch OFF and disconnect the negative
(-) battery cable.
|
| 2. |
Disconnect the ECM Connector (A).
|
| 3. |
Remove the battery (Refer to "Charging System" in
EM group).
|
| 4. |
Remove the mounting bolts and nut, and then remove
the ECM bracket assembly (A).
|
Installation
When replacing the ECM, the vehicle equipped with
the immobilizer must be performed procedure as below.
[In the ...
See also:
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature sensor connector.
3.
Measure resistance between ...
Removal
In case of removing the high pressure fuel pump,
high pressure fuel pipe, delivery pipe, and injector, there may be injury
...
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the center fascia garnish
(A).
...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com