1. |
With the washer motor connected to the reservoir tank, fill the
reservoir tank with water.
|
2. |
Connect positive (+) battery cables to terminal 1 and negative
(-) battery cables to terminal 2 respectively.
|
3. |
Check that the motor operates normally and the washer motor runs
and water sprays from the front nozzles.
|
4. |
If they are abnormal, replace the washer motor.
Connector No.1 : Windshield washer(+),
2 : Ground
|
Care of seat belts
Seat belt systems should never be disassembled or modified. In addition, care
should be taken to assure that seat belts and belt hardware are not damaged by seat
hinges, doors or other abuse.
WAR ...
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes.
...
Removal
1.
Release the residual pressure in fuel line (Refer
to “Release Residual Pressure in Fuel Line” in this group).
2.
Remove the rear sea ...