Hyundai Accent: Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the steering column upper (A) and lower (B) shrouds after
removing 3 screws.
|
| 3. |
Disconnect the connector. Release the lock of wiper switch using
tool without removing the steering wheel and the clock spring.
Remove the wiper and washer switch.
|
Inspection
Check for continuity between the terminals while operating the wiper and
washer switch. If it is not normal condition, replace wiper and wiper switch.
Wiper Switch
Washer Switch ...
Installation
1.
Install the wiper switch.
2.
Install the steering column upper and lower shrouds.
...
See also:
Windshield washers
In the OFF position, pull the lever gently toward you to spray washer fluid on
the windshield and to run the wipers 1-3 cycles.
Use this function when the windshield is dirty.
The spray and wipe ...
Hill-start assist control (HAC)
Hill start Assist Control is a convenience function. The main intent is to prevent
the vehicle from rolling backwards while taking off uphill from a stop. HAC holds
the braking pressure built up b ...
Inspection
Remove the overhead console lamp assembly then check for continuity between
terminals. If the continuity is not as specified, replace the map lamp switch.
...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com