Hyundai Accent: Cruise control system
➀ CRUISE indicator
➁ SET indicator
The cruise control system allows you to program the vehicle to maintain a constant speed without resting your foot on the accelerator pedal.
This system is designed to function above approximately 25 mph (40 km/h).
WARNING
- If the cruise control is left on, (CRUISE indicator light in the instrument cluster illuminated) the cruise control can be activated unintentionally. Keep the cruise control system off (CRUISE indicator light OFF) when the cruise control is not in use, to avoid inadvertently setting a speed.
- Use the cruise control system only when traveling on open highways in good weather.
- Do not use the cruise control when it may not be safe to keep the car at a constant speed, for instance, driving in heavy or varying traffic, or on slippery (rainy, icy or snow-covered) or winding roads or over 6% up-hill or down-hill roads.
- Pay particular attention to the driving conditions whenever using the cruise control system.
- Be careful when driving downhill using the cruise control system, which may increase the vehicle speed.
CAUTION
During cruise-speed driving of a manual transaxle vehicle, do not shift into neutral without depressing the clutch pedal, since the engine will be overrevved. If this happens, depress the clutch pedal or release the cruise control ONOFF switch.
NOTICE
- During normal cruise control operation, when the SET switch is activated or reactivated after applying the brakes, the cruise control will energize after approximately 3 seconds. This delay is normal.
- To activate cruise control, depress the brake pedal at least once after turning the ignition switch to the ON position or starting the engine. This is to check if the brake switch which is important part to cancel cruise control is in normal condition.
- To set cruise control speed
- To increase cruise control set speed
- To decrease the cruising speed
- To temporarily accelerate with the cruise control on
- To cancel cruise control, do one of the following
- To resume cruising speed at more than approximately 25 mph (40 km/h)
- To turn cruise control off, do one of the following
Hill-start assist control (HAC)
Hill start Assist Control is a convenience function. The main intent is to prevent
the vehicle from rolling backwards while taking off uphill from a stop. HAC holds
the braking pressure built up b ...
To set cruise control speed
1. Push the cruise ON-OFF button on the steering wheel to turn the system on.
The CRUISE indicator light in the instrument cluster will illuminate.
2. Accelerate to the desired speed, which must ...
See also:
Repair procedures
Component Replacement After Deployment
Before doing any SRS repairs, use the GDS to check for DTCs. Refer
to the Diagnostic Tr ...
Sunroof Motor. Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the roof trim. (Refer to the BD group - " Roof trim")
...
Interior care
Interior general precautions
Prevent chemicals such as perfume, cosmetic oil, sun cream, hand cleaner, and
air freshener from contacting the interior parts because they may cause damage or
discol ...
Hyundai Accent Manuals
