Hyundai Accent: Replacement
Hyundai Accent RB (2010-2018) Service Manual / General Information / Replacement
Standard values, such as torques and certain adjustments,
must be strictly observed in the reassembly of all parts.
If removed, the following parts should always be replaced
with new ones.
| 1. |
Oil seals
|
| 2. |
Gaskets
|
| 3. |
O-rings
|
| 4. |
Lock washers
|
| 5. |
Cotter pins (split pins)
|
| 6. |
Plastic nuts
Depending on their location.
|
| 7. |
Sealant should be applied to gaskets.
|
| 8. |
Oil should be applied to the moving components of
parts.
|
| 9. |
Specified oil or grease should be applied to the
prescribed locations (oil seals, etc) before assembly.
|
Adjustment
Use gauges and testers to adjust correctly the parts to standard
values correctly.
Parts
When replacing parts, use HYUNDAI genuine parts.
...
Electrical System
1.
Be sure to disconnect the battery cable from the
negative (-) terminal of the battery.
2.
Never pull on the wires when disconnecting con ...
See also:
Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the hydraul ...
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
...
Installation
•
Install the component with the specified
torques.
•
...
Hyundai Accent Manuals
© 2011-2025 Copyright www.hamanual.com