1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the trunk trim.
(Refer to the BD group - " Trunk Lid")
|
3. |
Disconnect the connector and remove the bulb (A).
|
4. |
Replace the bulb.
|
Exhaust Manifold. Repair
procedures
Removal and Installation
1.
Remove the engine cover.
2.
Disconnect the battery negative terminal.
Tightening torque ...
Rail Pressure Sensor (RPS). Troubleshooting
Signal Waveform
...
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and
various engine speed.
...