Hyundai Accent: Installation
Installation is in the reverse order of removal.
Perform the following :
| • |
Adjust a shift cable.
|
| • |
Refill engine with engine oil.
|
| • |
Refill a transaxle with fluid.
|
| • |
Refill power steering fluid.
|
| • |
Refill a radiator and a reservoir tank with engine
coolant.
|
| • |
Clean battery posts and cable terminals and assemble.
|
| • |
Inspect for fuel leakage.
|
| - |
After assemble the fuel line, turn on the ignition
switch (do not operate the starter) so that the fuel pump runs for approximately
two seconds and fuel line pressurizes.
|
| - |
Repeat this operation two or three times, then check
for fuel leakage at any point in the fuel line.
|
| • |
Bleed air from the cooling system.
|
| - |
Start engine and let it run until it warms up. (until
the radiator fan operates 3 or 4 times.)
|
| - |
Turn Off the engine. Check the level in the radiator,
add coolant if needed. This will allow trapped air to be removed from
the cooling system.
|
| - |
Put radiator cap on tightly, then run the engine
again and check for leaks.
|
Removal
•
Use fender covers to avoid damaging painted
surfaces.
•
...
Timing System.
...
See also:
Front Body F ( 5Door )
Engine mounting bracket hole (Ø11)
Battery tray leg bracket tooling hole
(Ø12)
Engine m ...
To temporarily accelerate with the cruise control on
If you want to speed up temporarily when the cruise control is on, depress the
accelerator pedal. Increased speed will not interfere with cruise control operation
or change the set speed.
To retu ...
Wheel replacement
When replacing the metal wheels for any reason, make sure the new wheels are
equivalent to the original factory units in diameter, rim width and offset.
WARNING
A wheel that is not the correct si ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com