Hyundai Accent Manuals

Hyundai Accent: Removal and Installation - Battery. Repair procedures - Charging System - Engine Electrical SystemHyundai Accent: Removal and Installation

Hyundai Accent RB (2010-2018) Service Manual / Engine Electrical System / Charging System / Battery. Repair procedures / Removal and Installation

1.
Disconnect the battery terminals (A). Disconnect the negative terminal first.
Tightening torque
(-) terminal :
4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft)
(+) terminal :
7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2lb-ft)

2.
Remove the air duct and air cleaner assembly. (Refer to EM group)
3.
Remove the battery insulation pad (A).
4.
Remove the battery (B) after removing the mounting bracket.
Tightening torque :
9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)

5.
Disconnect the ECM connectors (A) and then remove the ECM (B) and the battery tray (C).
Tightening torque
ECM bracket bolts & nut :
9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)
Battery tray bolts :
9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)

6.
Installation is the reverse order of removal.
When installing the battery, fix the mounting bracket on the tray correctly.

Battery. Repair procedures
...

Inspection
Battery Diagnostic Flow Vehicle parasitic current inspection 1. Turn the all electric devices OFF, and then turn the ignition switch OFF. ...

See also:

Removal
• DON’T remove the camshaft position sensor while the engine is running or right after engi ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the rear seat (Refer to "Seat" in BD gro ...

General Service Information
Protection Of The Vehicle Always be sure to cover fenders, seats, and floor areas before starting work. The support rod m ...

Hyundai Accent Manuals


© 2011-2025 Copyright www.hamanual.com