Hyundai Accent: Removal and Installation
Hyundai Accent RB (2010-2018) Service Manual / Engine Electrical System / Starting System / Starter. Repair procedures / Removal and Installation
| 1. |
Disconnect the battery negative terminal.
|
| 2. |
Remove the air duct and air cleaner assembly. (Refer
to EM group)
|
| 3. |
Disconnect the starter cable (B) from the B terminal
on the solenoid then disconnect the connector (A) from the S terminal.
|
| 4. |
Remove the 2 bolts holding the starter, then remove
the starter (A).
|
| 5. |
Installation is the reverse of removal.
|
| 6. |
Connect the battery negative terminal last.
|
Disassembly
1.
Disconnect the M-terminal (A) on the magnet switchassembly.
2.
After loosening the 2 screws (A), detach the magnetswitch
assembl ...
See also:
Repair procedures
Component Replacement After Deployment
Before doing any SRS repairs, use the GDS to check for DTCs. Refer
to the Diagnostic Tr ...
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
Servicing The Electrical System
1.
Prior to servicing the electrical system, be sure
to turn off the ignition switch and disconnect the battery ground cable.
...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com