Hyundai Accent: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
|
| 2. |
Lift the vehicle.
|
| 3. |
Disconnect the canister close valve connector (A).
|
| 4. |
Disconnect the ventilation hose (B) from the fuel
tank air filter and canister close valve.
|
| 5. |
Remove the fuel tank air filter assembly after removing
a bolt (A).
|
| 6. |
Remove the bracket (A) after pulling it.
|
| 7. |
Release the lever (A), and then separate the canister
close valve (B) from the fuel tank air filter (C) after rotating it
in the direction of the arrow in the figure.
|
Installation
•
Install the component with the specified
torques.
...
See also:
SRSCM Connector terminal
Pin
Function (Connector A)
Pin
Function (Connector B)
1
Ignition
1
Seat belt pretensioner [Drive ...
Removal and Installation
Water Pump
1.
Drain engine coolant.
System is under high pressure ...
Accelerator Position Sensor
(APS). Specifications
Specification
Accelerator
Position
Output Voltage (V)
APS1
APS2
C.T
0.7 ~ 0.8
0.275 ~ 0.475
...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com