Hyundai Accent: Removal
When replacing the ECM, the vehicle equipped with
the immobilizer must be performed procedure as below.
[In the case of installing used ECM]
1) Perform "ECM Neutral mode" procedure with GDS.
(Refer to Body Electrical System - "Immobilizer system")
2) After finishing "ECM Neutral mode", perform "Key
teaching" procedure with GDS. (Refer to Body Electrical System - "Immobilizer
system")
[In the case of installing new ECM]
Perform "Key teaching" procedure with GDS. (Refer
to Body Electrical System - "Immobilizer system")
|
| 1. |
Turn ignition switch OFF and disconnect the negative
(-) battery cable.
|
| 2. |
Disconnect the ECM Connector (A).
|
| 3. |
Remove the battery (Refer to "Charging System" in
EM group).
|
| 4. |
Remove the mounting bolts and nut, and then remove
the ECM bracket assembly (A).
|
Installation
When replacing the ECM, the vehicle equipped with
the immobilizer must be performed procedure as below.
[In the ...
See also:
Notes on the safe use of the Tire Mobility Kit
Park your car at the side of the road so that you can work with the Tire
Mobility Kit away from moving traffic.
To be sure your vehicle will not move, even when you're on fairly level
g ...
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Disconnect the variable intake solenoid valve connector
...
Distributing the sealant
11. Immediately drive approximately 4~6miles (7~10km or, about 10min) to evenly
distribute the sealant in the tire.
Do not exceed a speed of 50 mph (80 km/h). If possible, do not fall below a speed ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com