Hyundai Accent: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
|
| 2. |
Remove the resonator and the air intake hose (Refer
to “Intake And Exhaust System” in EM group).
|
| 3. |
Disconnect the ETC module connector (A).
|
| 4. |
Disconnect the coolant hoses (A).
|
| 5. |
Remove the installation bolts, and then remove the
ETC module (A) from the engine.
|
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of
...
Installation
•
Install the component with the specified
torques.
•
...
See also:
Replacement
Hood Assembly Replacement
•
When removing and installing the hood, an assistant is
neces ...
Defroster
CAUTION
To prevent damage to the conductors bonded to the inside surface of the
rear window, never use sharp instruments or window cleaners containing abrasives
to clean the window.
NOTICE
If ...
Camshaft Position Sensor
(CMPS). Troubleshooting
Wave Form
...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com