Hyundai Accent: Inspection

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Engine Coolant Temperature Sensor (ECTS). Repair procedures / Inspection

1.	Turn the ignition switch OFF.

2.	Remove the ECTS (Refer to "Removal").

3.	After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals 3 and 4.

4.

Check that the resistance is within the specification.

Specification: Refer to “Specification”

Engine Coolant Temperature Sensor (ECTS). Repair procedures

...

Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the engine coolant temperature sensor con ...

See also:

Trunk Trim. Repair procedures
Replacement • Put on gloves to protect your hands. • ...

Installation
1. Place the thermostat in the block. Install the thermostat (B) with the jiggle valve upward. 2. Install the water inlet fitting ( ...

Change to "winter weight" oil if necessary
In some climates it is recommended that a lower viscosity "winter weight" oil be used during cold weather. See section 8 for recommendations. If you aren't sure what weight oil you s ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com