Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Engine Coolant Temperature Sensor (ECTS). Repair procedures / Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the engine coolant temperature sensor connector (A).

3.	Supplement the engine coolant (Refer to “Cooling System” in EM group).

Inspection

1. Turn the ignition switch OFF. 2. Remove the ECTS (Refer to "Removal"). 3. After immersing the ther ...

Installation

• Install the component with the specified torques. • ...

See also:

To resume cruising speed at more than approximately 25 mph (40 km/h)
If any method other than the cruise ON/OFF switch was used to cancel cruising speed and the system is still activated, the most recent set speed will automatically resume when the RES+ switch is ...

Steering Gear box. Components and Components Location
Components 1. Tie-rod end 2. Lock nut 3. Bellows clip 4. Bellows 5. Tie rod 6. Rack bar 7. Dust packing 8. Dust cap 9. Oil seal 10. Pinion plug ...

Components and Components Location
Component Location 1. Driver power window switch 2. Door lock switch 3. BCM (Body Control Module) 4. Front door lock actuator 5. Rear door lock actuator 6. I ...

Hyundai Accent Manuals

© 2011-2025 Copyright www.hamanual.com