Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Crankshaft Position Sensor (CKPS). Repair procedures / Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the crankshaft position sensor connector (A) and remove the sensor (B) after removing the installation bolt.

Inspection

1. Check signal waveform of CKPS and CMPS using a GDS. Specification: Refer to “Waveform” ...

Installation

• Install the component with the specified torques. • ...

See also:

Fuel Pressure Control Valve. Repair procedures
Inspection 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the fuel pressure regulator valve ...

Installation
1. Installation is the reverse of removal. • ...

Installation
• Be sure to check the low pressure fuel hose quick-connector (A) is completely connected to ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com