Hyundai Accent: Fuel Pressure Control Valve. Repair procedures
Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Fuel Pressure Control Valve. Repair procedures
Inspection
| 1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
|
| 2. |
Disconnect the fuel pressure regulator valve connector.
|
| 3. |
Measure resistance between the fuel pressure regulator
valve terminals 1 and 2.
|
| 4. |
Check that the resistance is within the specification.
|
Fuel Pressure Control Valve. Schematic Diagrams
Circuit Diagram
(M/T)
(A/T)
...
Canister Close Valve (CCV). Description and Operation
Description
Canister Close Valve (CCV) is normally open and is installed
on the canister ventilation line. It seals evaporative emission control system
by shutting the canister from the atmo ...
See also:
Oil Pressure Switch. Repair
procedures
Inspection
1.
Check the continuity between the terminal and the
body with an ohmmeter. If there is no continuity, replace the oil pressure
switch.
...
If the engine overheats
If your temperature gauge indicates overheating, you experience a loss of power,
or hear loud pinging or knocking, the engine is probably too hot. If this happens,
you should:
1. Pull off the roa ...
Installation
When replacing the ECM, the vehicle equipped with
the immobilizer must be performed procedure as below.
[In the ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com