Hyundai Accent Manuals

Hyundai Accent: Removal - Camshaft Position Sensor (CMPS). Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Camshaft Position Sensor (CMPS). Repair procedures / Removal

•
DON’T remove the camshaft position sensor while the engine is running or right after engine is turned off. The part and engine oil is hot and can cause burns.
[Bank 1 / Intake]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the camshaft position sensor connector (A).
3.
Remove the installation bolt (B), and then remove the sensor.
[Bank 1 / Exhaust]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the camshaft position sensor connector (A).
3.
Remove the hanger and the protector.
4.
Remove the installation bolt (B), and then remove the sensor.

Inspection
1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” ...

Installation
• Install the component with the specified torques. • ...

See also:

How to use this manual
We want to help you get the greatest possible driving experience from your vehicle. Your Owner’s Manual can assist you in many ways. We strongly recommend that you read the entire manual. In ord ...

Inspection
1. Turn the ignition switch OFF. 2. Disconnect the PCSV connector. 3. Measure resistance between the PCSV termi ...

Sunroof
If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof with the sunroof control switch located on the overhead console. The sunroof can only be opened, closed, or tilted w ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com