Hyundai Accent: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
|
| 2. |
Remove the rear seat (Refer to "Seat" in BD group).
|
| 3. |
Remove the fuel pump service cover (A).
|
| 4. |
Disconnect the fuel tank pressure sensor connector.
|
| 5. |
Remove the fuel tank pressure sensor (A) after releasing
the hooks vertically.
|
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.
Specification:
...
Installation
•
Install the component with the specified
torques.
•
...
See also:
Side repeater light bulb replacement
Type A
1. Remove the light assembly from the vehicle by prying the lens and pulling
the assembly out.
2. Disconnect the bulb electrical connector.
3. Separate the socket and the lens parts by t ...
Console. Repair procedures
Replacement
Floor Console Replacement
[ M/T ]
•
When prying with a flat-tip screw ...
Interior E ( 5Door )
Front pillar trim mounting hole (Ø8.5)
Front pillar trim mounting hole (Ø8)
Cowl cross ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com