Hyundai Accent Manuals

Hyundai Accent: Installation - Injector. Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Installation

1.
Combustion seal
2.
Rubber washer
3.
Support disc
4.
O-ring
•
Do not reuse the used injector fixing clip.
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
•
Apply engine oil to the injector O-ring.
•
Do not reuse the used injector O-ring.
•
Do not reuse the used bolt.
•
When inserting the injector, be careful not to damage the injector tip.
•
Do not reuse the support disc.
•
Do not reuse the injector rubber washer.
•
When replacing the rubber washer, the steal plate (A) part should be faced the cylinder installation part and the rubber plate (B) part should be faced the injector body part.

•
Do not reuse the combustion seal.
1.
Installation is reverse of removal.

Removal
In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury ...

Replacement
The injector combustion seal should be replaced new one to prevent leakage after removing the injector. 1. Remove the combustion seal (A) with a wire cutter. ...

See also:

To set cruise control speed
1. Push the cruise ON-OFF button on the steering wheel to turn the system on. The CRUISE indicator light in the instrument cluster will illuminate. 2. Accelerate to the desired speed, which must ...

Inspection
1. Check the coil spring for crack and deformation. 2. Check the coil spring pad for damage and deformation. ...

CVVT Oil Control Valve (OCV). Description and Operation
Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com