1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
|
2. |
Disconnect the purge control solenoid valve connector
(A).
|
3. |
Disconnect the vapor hoses (B) from the purge control
solenoid valve.
|
4. |
Remove the valve after removing the bolt (C).
|
ETC (Electronic Throttle
Control) System. Troubleshooting
Fail-Safe Mode
Item
Fail-Safe
ETC Motor
Throttle valve stuck at 7°
TPS
TPS 1 fault
ECM looks at TPS2
...
Windshield wipers
Operates as follows when the ignition switch is turned ON.
MIST : For a single wiping cycle, push the lever upward and release it with the
lever in the OFF position. The wipers will operate continu ...
Removal
1.
Disconnect the battery negative cable and wait for at least 3
minutes before beginning work.
2.
Remove the roof trim.
(Refer to ...