Hyundai Accent: Installation
Be sure to install the harness wires not to be pinched or interfered
with other parts.
|
|
| 1. |
Remove the ignition key from the vehicle.
|
| 2. |
Disconnect the battery negative cable and wait for at least three
minutes.
|
| 3. |
Install the new seat back assembly.
(Refer to the Body group - "Seat")
|
| 4. |
Install the front seat assembly.
(Refer to the Body group - "Seat")
|
| 5. |
Recline and slide the front seat forward fully, make sure the
harness wires are not pinched of interfering with other parts.
|
| 6. |
Reconnect the battery negative cable.
|
| 7. |
After installing the side airbag (SAB), confirm proper system
operation:
|
Removal
Curtain Airbag (CAB) Module. Description
and OperationFuel Filler Cap.
Description and Operation
Description
A ratchet tightening device on the threaded fuel filler cap
reduces the chances of incorrect installation, which seals the fuel filler.
After the gasket on the fuel filler cap an ...
To keep locks from freezing
To keep the locks from freezing, squirt an approved de-icer fluid or glycerine
into the key opening. If a lock is covered with ice, squirt it with an approved
de-icing fluid to remove the ice. If ...
Roof Trim. Repair procedures
Replacement
Sunvisor Replacement
•
When prying with a flat-tip screwdriver, wrap it with
...