Hyundai Accent Manuals

Hyundai Accent: Removal - Canister Close Valve (CCV). Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Canister Close Valve (CCV). Repair procedures / Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Lift the vehicle.
3.
Disconnect the canister close valve connector (A).
4.
Disconnect the ventilation hose (B) from the fuel tank air filter and canister close valve.
5.
Remove the fuel tank air filter assembly after removing a bolt (A).
6.
Remove the bracket (A) after pulling it.
7.
Release the lever (A), and then separate the canister close valve (B) from the fuel tank air filter (C) after rotating it in the direction of the arrow in the figure.

Inspection
1. Turn the ignition switch OFF. 2. Disconnect the CCV connector. 3. Measure resistance between the CCV termina ...

Installation
• Install the component with the specified torques. • ...

See also:

Engine Coolant Temperature Sensor (ECTS). Description and Operation
Description Engine Coolant Temperature Sensor (ECTS) is located in the engine coolant passage of the cylinder head for detecting the engine coolant temperature. The ECTS uses a thermistor th ...

Accelerator Position Sensor (APS). Description and Operation
Description Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important senso ...

TCM Terminal Input/ Output Signal
Connector [CHG-AA] Pin Description Condition Input/output value Type Level 22 Overdrive clutch c ...

Hyundai Accent Manuals


© 2011-2025 Copyright www.hamanual.com