Hyundai Accent Manuals

Hyundai Accent: Removal - Clutch Pedal. Repair procedures - Clutch System - Clutch SystemHyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Clutch System / Clutch System / Clutch Pedal. Repair procedures / Removal

•
Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.
1.
Disconnect the ignition lock switch connector (A) and clutch switch (B).

2.
Disconnect the push rod from the clutch pedal by removing the snap pin (A) and washer.
3.
Remove the clutch pedal mounting nuts (A-3ea, B-1ea).
Tightening torque:
(A) 12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)
(B) 18.6 ~ 23.5 .Nm (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)

4.
Remove the clutch pedal assembly.

Inspection
Clutch Pedal Inspection 1. Measure the clutch pedal height (from the face of the pedal pad to the floor board) and the clutch pedal clevis pin play (measu ...

Installation
1. Installation is the reverse of removal. ...

See also:

Input/Output Specification
...

Inspection
1. Immerse the thermostat in water and gradually heat the water. 2. Check the valve opening temperature. ...

Inspection
TCM Problem Inspection Procedure 1. TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis ground using the backside of TCM harness connector as TCM side ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com