Hyundai Accent: Adjustment
| Clutch Release Cylinder Air Bleeding Procedure |
Use the specified fluid. Avoid mixing different brands
of fluid.
|
Specified fluid:
SAE J1703 (DOT 3 or DOT 4)
|
| 1. |
After disconnecting a cap from the clutch release
cylinder air bleeder, insert a vinyl hose in the plug.
|
| 2. |
Loosening the plug screw, press and release the clutch
pedal about 10 times.
|
| 3. |
Tighten the plug (A) during the clutch pedal pressed.
Afterwards, raise the pedal with a hand.
|
| 4. |
After pressing the clutch pedal 3 times more, loosen
the plug (A) and retighten it with the pedal pressed. Raise it again,
then.
|
| 5. |
Repeat the step 4 two or three times. (until there
is no bubble in the fluid)
|
| 6. |
Refill the clutch master cylinder with the specified
fluid.
|
Installation
1.
Installation is the reverse of removal.
Coat the clutch clevis push ro ...
See also:
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Lift the vehicle.
3.
D ...
Hands free mic. Repair procedures
Inspection
1.
Disconnect the negative(-) battery terminal.
2.
Remove the roof trim.
(Refer to the BD group - "Roof trim")
...
Inspection
Rear Brake Disc Thickness Check
1.
Check the brake pads for wear and fade.
2.
Check the brake disc for damage and cracks.
...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com