Hyundai Accent Manuals

Hyundai Accent: Installation - Input Speed Sensor. Repair procedures - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Input Speed Sensor. Repair procedures / Installation

1.
Installation is the reverse of removal.
•
The gasket of the valve body cover gasket (A) use new one.
•
Adding automatic transaxle fluid.
(Refer to "Hydraulic system (Fluid)" in this group)

•
Perform TCM learning after replacing the automatic transaxle to prevent slow automatic transaxle response, jerky acceleration and jerky startup.
(Refer to "Automatic transaxle control system (Repair procedures)" in this group)

Removal
1. Remove the battery and the battery tray. (Refer to "Charging system" in EE group.) 2. Remove the under cover (A). ...

Output Speed Sensor. Description and Operation
Description The output speed sensor (A) is a vital unit that measures the rate of rotation of the transaxle's turbine shaft and output shaft, and delivers the readings to the TCM. The se ...

See also:

Installation
1. Install the rear combination lamp assembly. 2. Connect the rear combination lamp assembly connector. 3. Conn ...

SS-A Solenoid Valve(ON/OFF). Specifications
Specifications ON/OFF Solenoid Valve(SS-A, SS-B) ▷ Control type : Normal low type Control pressure kpa (kgf/cm², psi) 490.33(5.0, 71.12) ...

Output Speed Sensor. Troubleshooting
Signal Waveform Fig 1) Input/Output speed sensor at low speed Fig 2) Input/Output speed sensor at high speed ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com