Hyundai Accent: Automatic Transaxle System

Replacement

1. Disconnect the back up lamp switch connector (A). 2. Remove the back up lamp switch (A). 3. ...

General Information

...

See also:

Installation
1. Installation is reverse of removal. Accelerator pedal module installation nut: 12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 ...

Rail Pressure Sensor (RPS). Troubleshooting
Signal Waveform ...

Starting / Switching off the engine with Keyless Entry and Starting
The electronic key must be present in the passenger compartment. If it is not detected, a message is displayed. Move the electronic key so that the engine can be started or switched off. If there ...