Hyundai Accent Manuals

Hyundai Accent: Removal - Inhibitor Switch. Repair procedures - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Inhibitor Switch. Repair procedures / Removal

1.
Make sure vehicle does not roll before setting room side shift lever and T/M side manual control lever to "N" position.
2.
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
3.
Remove the air cleaner assembly.
(Refer to "Intake manifold" in EM group.)
4.
Remove the shift cable mounting nut (B).
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 Kgf.m, 5.7 ~ 8.6 lb-ft)
5.
Disconnect the inhibitor switch connector (A).
6.
Remove the manual control lever (B) and the washer after removing a nut (A).

When installing, affix the manual control lever and the inhibitor switch with Ø5mm (0.1969in.). Then tighten the inhibitor assembly mounting bolts.
7.
Remove the inhibitor assembly (A) after removing the bolts (2ea).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

When installing, tighten the inhibitor assembly mounting bolt lightly, so that necessary adjustments can be made. Tighten to specifications.

Inhibitor Switch. Repair procedures
...

Installation
1. Installation is the reverse of removal. ...

See also:

Removal and Installation
1. Disconnect the battery terminals. (Refer to Engine and transaxle assembly in this group) 2. Remove the air cleaner assembly. (Refer to E ...

Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraul ...

Rear Seat. Components and Components Location
Components 1. Headrest [RH] 2. Rear seat back cover [RH] 3. Rear seat back frame assembly [RH] 4. Rear back cover [RH] 5. Headrest [Center] 6. Headrest [LH] 7 ...

Hyundai Accent Manuals

В© 2011-2026 Copyright www.hamanual.com