Hyundai Accent: Repair procedures
Hyundai Accent RB (2010-2018) Service Manual / Restraint (Depowered) / General Information / Repair procedures
Component Replacement After Deployment
Before doing any SRS repairs, use the GDS to check for DTCs. Refer
to the Diagnostic Trouble Code list for repairing of the related DTCs.
|
If the front airbag(s) deployed after a collision, replace the following
items.
| - |
SRSCM
|
| - |
Deployed airbag(s)
|
| - |
Seat belt pretensioner(s)
|
| - |
Front impact sensor
|
| - |
SRS wiring harnesses
|
| - |
Inspect the clock spring for heat damage.
If any damage found, replace the clock spring.
|
If the side/curtain airbag(s) deployed after a collision, replace the
following items.
| - |
SRSCM
|
| - |
Deployed airbag(s)
|
| - |
Side impact sensor(s) for the deployed side(s)
|
| - |
SRS wiring harnesses
|
| - |
Deployed seat belt pretensioner(s)
|
After the vehicle is completely repaired, confirm the SRS airbag system
is OK.
| - |
Turn the ignition switch ON; the SRS indicator should come on
for about six seconds and then go off.
|
Description and Operation
Warning Lamp Activation
Warning Lamp Behavior after Ignition
On
As soon as the operating voltage is applied to the SRSCM ignition input,
the SRSCM activates the warning lamp fo ...
See also:
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable from battery and wait for
at least three minutes befo ...
Blade inspection
NOTICE
Commercial hot waxes applied by automatic car washes have been known to make
the windshield difficult to clean.
Contamination of either the windshield or the wiper blades with foreign ma ...
Variant coding
After replacing the SRSCM with a new one, must be performed the “Variant
Coding” procedure.
1.
On ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com