Hyundai Accent Manuals

Hyundai Accent: SRS Control Module (SRSCM). Description and 
Operation - SRSCM - Restraint (Depowered)Hyundai Accent: SRS Control Module (SRSCM). Description and Operation

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Depowered) / SRSCM / SRS Control Module (SRSCM). Description and Operation

Description

The primary purpose of the SRSCM (Supplemental Restraints System Control Module) is to discriminate between an event that warrants restraint system deployment and an event that does not. The SRSCM must decide whether to deploy the restraint system or not. After determining that pretensioners and/or airbag deployment is required, the SRSCM must supply sufficient power to the pretensioners and airbag igniters to initiate deployment.
The SRSCM determines that an impact may require deployment of the pretensioners and airbags from data obtained from impact sensors and other components in conjunction with a safing function.
The SRSCM will not be ready to detect a crash or to activate the restraint system devices until the signals in the SRSCM circuitry stabilize.
It is possible that the SRSCM could activate the safety restraint devices in approximately 3 seconds but is guaranteed to fully function after prove-out is completed.
The SRSCM must perform a diagnostic routine and light a system readiness indicator at key-on. The system must perform a continuous diagnostic routine and provide fault annunciation through a warning lamp indicator in the event of fault detection. A serial diagnostic communication interface will be used to facilitate servicing of the restraint control system.

SRSCM
...

SRS Control Module (SRSCM). Components and Components Location
Components ...

See also:

Instrument Cluster. Description and Operation
Description Function Tail lamp warning buzzer - This function dose not operate if the vehicle equipped BCM. - With the tail lamp sw ...

Description
The immobilizer system will disable the vehicle unless the proper ignition key is used. In addition to the currently available anti-theft systems such as car alarms, the immobilizer system ai ...

PODS-F Zeroing procedure
You should perform PODS-F Re-zero procedure after service or replacement about all part of the passenger seat. (Not included full seat assembly) 1. Ignition “OFF� ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com