Hyundai Accent Manuals

Hyundai Accent: Installation - Side Impact Sensor (SIS). Repair procedures - SRSCM - Restraint (Depowered)Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Depowered) / SRSCM / Side Impact Sensor (SIS). Repair procedures / Installation

Side Impact Sensor
•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.
1.
Install the new side impact sensor with the bolt then connect the side impact sensor connector.
Tightening torque:
7.0 ~ 9.0 N.m (0.71 ~ 0.92 kgf.m, 5.2 ~ 6.6 lb-ft)
2.
Install the center pillar trim.
(Refer to the Body group - "Interior trim")
3.
Install the door scuff trim.
(Refer to the Body group - "Interior trim")
4.
Reconnect the battery negative cable.
5.
After installing the Side Impact Sensor, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Removal
Side Impact Sensor 1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Remove the d ...

Schematic Diagrams
...

See also:

Knock Sensor (KS). Description and Operation
Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knoc ...

Transaxle Oil Temperature Sensor. Description and Operation
Description Transaxle oil temperature sensor monitors the automatic transaxle fluid's temperature and conveys the readings to TCM. It is an NTC (Negative Thermal Coefficient) sensor whos ...

Components and Components Location
Component Location 1. Driver power window switch 2. Door lock switch 3. BCM (Body Control Module) 4. Front door lock actuator 5. Rear door lock actuator 6. I ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com