1. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
2. |
Remove the door scuff trim.
(Refer to the Body group - "Interior trim")
|
3. |
Remove the center pillar trim.
(Refer to the Body group - "Interior trim")
|
4. |
Disconnect the side impact sensor connector (A).
|
5. |
Loosen the side impact sensor mounting bolt (B) and remove the
side impact sensor.
|
Rear Body ( 5Door )
Side outer panel rear corner
Tail gate hinge mounting hole (Ø14)
Tail gate hinge mounting hole ...
Fuses
A vehicle’s electrical system is protected from electrical overload damage by
fuses.
This vehicle has 2 fuse panels, one located in the driver’s side panel bolster,
the other in the engine ...
Rear combination light bulb replacement (4 Door)
(1) Stop and tail light
(2) Rear turn signal light
(3) Back-up light
(4) Side marker
1. Open the trunk lid.
2. Remove the service cover by pulling out the service cover.
3. Remove the sock ...