Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Advanced) / SRSCM / Front Impact Sensor (FIS). Repair procedures / Removal

•	Removal of the airbag must be performed according to the precautions/ procedures described previously.

•	Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).

•	Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.

1.	Disconnect the battery negative cable, and wait for at least three minutes before beginning work.

2.	Remove the front bumper. (Refer to the Body group - "Front bumper")

3.	Remove the washer reservoir. (Refer to the Body Electrical group - "Washer motor") [Right side only]

4.	Remove the front impact sensor mounting bolt (A).

5.	Disconnect the front impact sensor connector (B).

6.	Remove the front impact sensor.

Front Impact Sensor (FIS). Repair procedures

...

Installation

• Do not turn the ignition switch ON and do not contact the battery cable while replacing the ...

See also:

Installation
• Install the component with the specified torques. • ...

Care of seat belts
Seat belt systems should never be disassembled or modified. In addition, care should be taken to assure that seat belts and belt hardware are not damaged by seat hinges, doors or other abuse. WAR ...

Removal
In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com