Hyundai Accent Manuals

Hyundai Accent: Installation - Front Impact Sensor (FIS). Repair procedures - SRSCM - Restraint (Advanced)Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Advanced) / SRSCM / Front Impact Sensor (FIS). Repair procedures / Installation

•
Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.
1.
Install the new front impact sensor.
2.
Tighten the front impact sensor mounting bolt.
Tightening torque:
7.0 ~ 9.0 N.m (0.71 ~ 0.92 kgf.m, 5.2 ~ 6.6 lb-ft)
3.
Connect the front impact sensor connector.
4.
Install the washer reservoir.
(Refer to the Body Electrical group - "Washer motor")
[Right side only]
5.
Install the front bumper.
(Refer to the Body group - "Front bumper")
6.
Reconnect the battery negative cable.
7.
After installing the Front Impact Sensor, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Removal
• Removal of the airbag must be performed according to the precautions/ procedures described ...

Side Impact Sensor (SIS). Description and Operation
Description Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pilla ...

See also:

Installation
1. Installation is the reverse of removal. • ...

Removal
1. Remove the battery and the battery tray. (Refer to "Charging system" in EE group.) 2. Remove the under cover (A). ...

Lubricants and Sealant
Items Recommnend lubricant Quantity Transaxle gear oil SAE 75W/85 API GL-4 TGO-8 (MS517-14) 1.8 ~ 1.9L (0.48 ~ 0.50 ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com