Hyundai Accent: Actual Measurement Dimensions ( 4Door )
Hyundai Accent RB (2010-2018) Service Manual / Body (Interior and Exterior) / Body Dimensions / Under Body. Body Repair / Actual Measurement Dimensions ( 4Door )
|
|
|
|
|
Front side member tooling hole (Ø6.6) |
Side cover mounting hole (B/B’: Ø6.6/ Ø8.6) |
Front sub frame mounting hole (Ø17) |
|
|
|
|
|
Front sub frame mounting hole (Ø22) |
Center floor side member tooling hole (Ø10) |
Center floor side member tooling hole (Ø6) |
|
|
|
|
|
Rear floor side member tooling hole (Ø8.8) |
Rear suspension mounting hole (Ø10) |
Rear suspension mounting hole (Ø10) |
|
|
|
|
|
Rear floor side member tooling hole (Ø8) |
Rear floor side member tooling hole (Ø15) |
|
Projected Dimensions ( 4 Door )
Front side member tooling hole (Ø6.6)
Side cover mounting hole
(B/B’: Ø6.6/ Ø8.6)
...
Projected Dimensions ( 5 Door )
Front side member tooling hole (Ø6.6)
Side cover mounting hole (Ø8.6)
Front sub frame m ...
See also:
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature sensor connector.
3.
Measure resistance between ...
Crankshaft Position Sensor
(CKPS). Troubleshooting
Waveform
This example shows a typical Crankshaft Position Sensor(CkPS)
and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection
and ignition timing by using ...
Installation
1.
Install the interior junction box.
2.
Install the crash pad lower panel.
3.
Check that all system operates n ...
Hyundai Accent Manuals
© 2011-2025 Copyright www.hamanual.com