Hyundai Accent Manuals

Hyundai Accent: Adjustment - Brake Pedal. Repair procedures - Brake System - Brake SystemHyundai Accent: Adjustment

Brake Pedal Height and Free Play
1.
Disconnect the stop lamp switch connector (A).

2.
Adjust the brake pedal height (A) as illustration below.

Pedal height (A): 173 mm (6.81 in)
Full stroke (C): 108 mm (4.25 in)

3.
Adjust the stop lamp switch clearance (B) and brake pedal free play.

Stop lamp clearance (B): 1.0 ~ 2.0 mm (0.04 ~ 0.08 in)
Pedal free play: 3.0 ~ 8.0 mm (0.12 ~ 0.31 in)

4.
Connect the stop lamp switch connector.
Stop lamp switch clearance adjustment
If the gap between stop lamp switch and bracket is not 1.0 ~ 2.0mm(0.04~ 0.08in), conform to below.
1.
Disconnect the stop lamp switch connector (A).

2.
Pull the locking plate (A) as indicated by the arrow.

3.
Turn stop lamp switch 45° counterclockwise and remove it.

4.
Fix the brake pedal arm and insert fully the stop lamp switch as hiding contact part.

5.
After inserting, turn the stop switch (A) 45° clockwise, and then assemble locking plate (B) by pushing.

6.
Confirm the gap between stop lamp switch and bracket.

Stop lamp clearance:
1.0 ~ 2.0 mm (0.04 ~ 0.08 in.)

7.
Connect the stop lamp switch connector.

Installation
1. Installation is the reverse of removal. • ...

Front Disc Brake. Components and Components Location
Components 1. Guide rod bolt 2. Bleed screw 3. Caliper body 4. Caliper carrier 5. Inner pad shim 6. Brake pad 7. Pad retainer ...

See also:

Rear combination light bulb replacement (4 Door)
(1) Stop and tail light (2) Rear turn signal light (3) Back-up light (4) Side marker 1. Open the trunk lid. 2. Remove the service cover by pulling out the service cover. 3. Remove the sock ...

Inspection
1. Operate the switch and check for continuity between terminals. ...

Repair procedures
Inspection Manual Transaxle Oil Inspection 1. Park the vehicle on a level ground and stop the engine. 2. Retighten the oil f ...

Hyundai Accent Manuals


© 2011-2025 Copyright www.hamanual.com