Hyundai Accent: Adjustment
| Clutch Release Cylinder Air Bleeding Procedure |
Use the specified fluid. Avoid mixing different brands
of fluid.
|
Specified fluid:
SAE J1703 (DOT 3 or DOT 4)
|
| 1. |
After disconnecting a cap from the clutch release
cylinder air bleeder, insert a vinyl hose in the plug.
|
| 2. |
Loosening the plug screw, press and release the clutch
pedal about 10 times.
|
| 3. |
Tighten the plug (A) during the clutch pedal pressed.
Afterwards, raise the pedal with a hand.
|
| 4. |
After pressing the clutch pedal 3 times more, loosen
the plug (A) and retighten it with the pedal pressed. Raise it again,
then.
|
| 5. |
Repeat the step 4 two or three times. (until there
is no bubble in the fluid)
|
| 6. |
Refill the clutch master cylinder with the specified
fluid.
|
Installation
1.
Installation is the reverse of removal.
Coat the clutch clevis push ro ...
See also:
Installation
1.
Place the thermostat in the block.
Install the thermostat (B) with the jiggle valve
upward.
2.
Install the water inlet fitting ( ...
Installation
1.
Installation is reverse of removal.
Fuel tank band
installation nut:
39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~
39.8 lb-ft ...
Installation
1.
Install the heater & air conditioning controller.
2.
Install the audio unit.
3.
Connect the battery (-) ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com