Hyundai Accent: Disassembly
Key lock assembly
| 1. |
Make a groove on the head of special bolts (A) by a punch.
|
| 2. |
Loosen the special bolt using a screw driver and then remove the
key lock assembly from the steering column assembly.
|
| 3. |
Reassembly is the reverse of the disassembly.
|
Universal joint assembly
| 1. |
Loosen the bolt (A) and then disconnect the universal joint assembly
from the steering column assembly.
|
| 2. |
Reassembly is the reverse of the disassembly.
|
Replacement
1.
Disconnect the battery negative cable from the battery and then
wait for at least 30 seconds.
2.
Turn the steering wheel so that the fro ...
Inspection
1.
Check the steering column for damage and deformation.
2.
Check the steering column for damage and deformation.
3.
...
See also:
Passive Occupant Detection System (PODS-F). Description and Operation
Description
In order to make normal activation of airbag system, SRSCM detects DTC(s)
for the Passive occupant detection system (PODS-F). If the seat is occupied,
PODS-F detects passenger pr ...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV termi ...
Repair procedures
General Inspection
After or before servicing the EPS system, perform the troubleshooting
and test procedure as follows. Compare the system condition with normal condition
in the table below ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com