Hyundai Accent Manuals

Hyundai Accent: Exhaust Manifold. Repair procedures - Intake And Exhaust System - Engine Mechanical SystemHyundai Accent: Exhaust Manifold. Repair procedures

Hyundai Accent RB (2010-2018) Service Manual / Engine Mechanical System / Intake And Exhaust System / Exhaust Manifold. Repair procedures

Removal and Installation

1.
Remove the engine cover.
2.
Disconnect the battery negative terminal.
Tightening torque :
4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft)
3.
Disconnect the front and rear oxygen sensor connectors (A).
4.
Remove the front muffler (A).
Tightening torque:
39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft)

5.
Remove the exhaust manifold stay (A).
Tightening torque:
39.2 ~ 49.0N.m (4.0 ~ 5.0kgf.m, 28.9 ~ 36.2lb-ft)

6.
Remove the heat protector (A).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

7.
Remove the exhaust manifold (A).
Tightening torque:
29.4 ~ 41.2N.m (3.0 ~ 4.2kgf.m, 21.7 ~ 30.4lb-ft)

When installing, replace with a new gasket.
When installing the intake manifold, tighten the nuts with pre-torque first, and then tighten the nuts with specified torque in the sequence shown.

8.
Installation is reverse order of removal.

Exhaust Manifold. Components and Components Location
Components 1. Heat protector 2. Exhaust manifold 4. Exhaust manifold gasket 5. Exhaust manifold stay ...

Muffler. Components and Components Location
Components 1. Front muffler 2. Catalytic converter & center muffler assembly 3. Main muffler 4. Gasket 5. Hanger ...

See also:

SS-A Solenoid Valve(ON/OFF). Schematic Diagrams
Circuit Diagram ...

Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. ...

Installation
1. Install the wiper switch. 2. Install the steering column upper and lower shrouds. ...

Hyundai Accent Manuals

В© 2011-2026 Copyright www.hamanual.com